PNW Guns Forum
Go Back   PNW Guns > PNW Guns > Reloading

Reply
 
LinkBack Thread Tools Display Modes
Old 02-07-2011, 05:21 PM   #1
Gunslinger
 
Joined: Jan 2011
From: Pasco,Wash
Posts: 57
9mm reloads

At the Pasco gun show I bought some pmc nontox small pistol primers, does anyone have good luck with them? And I bought the bulk 115 and 147 9mm from the guy with the pmc nontox did anyone buy those too, they seem like seconds some are dented, look like they were pulled from cases did you notice this?
 
Join PNW Guns


Welcome to PNW Guns, a gun and firearm community for gun owners in the Pacific Northwest. We welcome everyone and the community is free to join so register today and become part of the PNW Guns family!


Old 02-12-2011, 11:04 PM   #2
Gunslinger
 
Joined: Jan 2011
From: Pasco,Wash
Posts: 57
I bought some more 115gr 9mm at the kennewick gun show, found out that they are pulled bullets but for $5.00 for 100 seemed like a good deal and they looked a whole lot better this time no dents or messed up bottoms. The only problem I found is they fit in S&B, win, remington, dnl, speer, but Federal cases have too large an inside diameter and bullets don't grip in case tight enough. Bullets move in cases when I hold case and push against my reloading bench. SO if anyone bought some of these please be aware of this and seperate your brass.
 
Old 02-15-2011, 09:12 PM   #3
Gunslinger
 
Joined: Jan 2011
From: Pasco,Wash
Posts: 57
Hey I tried to reload the next batch of bullets and more than a few of these bullets fit way too loose in the cases, if you bought some be careful, I guess my next move is to find some onece fired brass and see if they fit better in those or crimp the brass arond the bullets.
 
Reply

  PNW Guns > PNW Guns > Reloading

Tags
9mm, reloads



Thread Tools
Display Modes



Facebook @pnwguns PNW Guns RSS Feed

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.6.0 ©2011, Crawlability, Inc.
Copyright 2009 - 2010 PNW Guns. All rights reserved.