Springs?

FatFugg · 04-04-2009, 07:42 PM

What store has a good selection of small straight pull springs? I am trying to reduce the trigger pull on my TP-9, but DSA only has standard replacement springs. It is a straight pull spring so if I can just find one roughly the same size with less tension I would like to give it a try.

KillermondoDude · 04-04-2009, 10:40 PM

umm clip a few rings?

FatFugg · 04-05-2009, 05:26 AM

Quote:

Originally Posted by KillermondoDude

umm clip a few rings?

Opposite. It doesn't push the trigger back into the resting position, it pulls it back. I thought about trying to stretch it out, but if I fugg it up I don't have a good spring & I can't use the pistola until I get a replacement.

Mic · 04-05-2009, 06:52 AM

Quote:

Originally Posted by FatFugg

Opposite. It doesn't push the trigger back into the resting position, it pulls it back. I thought about trying to stretch it out, but if I fugg it up I don't have a good spring & I can't use the pistola until I get a replacement.

If you are just looking for odd springs, you could try and see if Fastners on Oregon Ave in Pasco has a selection.

If there is a Tacoma Screw in the Tri-Cities, go there as well. I know they are getting pretty large, and there is one in Yakima, so I'm sure by now they have to have made it over there with the industry that takes place. If there is one, this would be my first stop, then Fastners.

FatFugg · 04-05-2009, 07:08 AM

Quote:

Originally Posted by Mic

If you are just looking for odd springs, you could try and see if Fastners on Oregon Ave in Pasco has a selection.

If there is a Tacoma Screw in the Tri-Cities, go there as well. I know they are getting pretty large, and there is one in Yakima, so I'm sure by now they have to have made it over there with the industry that takes place. If there is one, this would be my first stop, then Fastners.

Thanks, I will give them a shot!

04-04-2009, 07:42 PM	#1
FatFugg Sharpshooter Joined: Jan 2009 From: Dri-Shities Posts: 563	Springs? What store has a good selection of small straight pull springs? I am trying to reduce the trigger pull on my TP-9, but DSA only has standard replacement springs. It is a straight pull spring so if I can just find one roughly the same size with less tension I would like to give it a try.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

04-04-2009, 10:40 PM	#2
KillermondoDude Marksman Joined: Jan 2009 From: Washington on the wet side Posts: 328	umm clip a few rings?